Skip to main content
Tumble dryer does not stop when the cycle is finished
Zanussi Support

Tumble dryer does not stop when the cycle is finished

 

If the tumble dryer does not stop when the cycle is finished, this may be because of the “anti-crease” phase.

  • If the tumble dryer continues running in this phase for about 1 hour and can be stopped manually.
  • Turn the cycle selector to the Off position.
If the cycle runs much longer than 2-3 hours:

A cycle with a maximum drying level normally takes up to 2-3 hours.

  • The bed-linen cycles last longer.
  • There can be a problem with measuring moisture.

Possible causes:

  • Inappropriate grounding of the tumble dryer.
  • Connection by an extension cord.
  • Dirty felt tape / sensors in the drum. The drum and tape can be cleaned with vinegar.
  • Dirty filters, condenser or condenser compartment.

If the above does not resolve the problem, contact Authorized Service Center.

 

2017-08-16_1122.png

To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.

When contacting us, please have the following information to hand. You will find this information on the manufacturer’s data plate:

  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

Data plate with model number, product number/PNC, ELC and serial number:

modelnoexplanation1.gif
  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

[3–9999] Where will I find the data plate on my product? 

NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.

Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.

  • Report error code: JJ

Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.

You can request a visit by one of our engineers by clicking on the link below.