Skip to main content
Tumble dryer’s water tank is empty
Zanussi Support

Tumble dryer’s water tank is empty

 

This is normal if the water tank LED comes on after the first drying cycle and there is no water in the water tank.

  • Before the water is pumped to the water tank, it is collected in a large container.
Are the filters clean? Is the machine clean?

If the filters, condenser and/or heat exchanger are dirty, it may be the reason why the machine is not heating up.

The filters may appear clean but still be blocked.

  • You can check the filters by holding them up against the light or under a tap and seeing whether the water can flow through them.
  • If no water passes through the filters, clean them and check them again.
  • If water will still not pass through the filters, replace them.
  • Filters and accessories are available via the Webshop. (You can visit our Webshop by clicking on the link below).
Check whether the appliance is getting hot:

Before you book an engineer, it is important to check if the appliance’s heating system is working. 

  • Firstly, clean the appliance and then start a timed cycle of at least 120 minutes with no load.
  • After one hour, open the door and check whether the drum is hot inside (with at least 20 minutes remaining on the display).
  • If the inside of the drum is hot, the heating system is working. In tumble dryers fitted with a heat pump, you can often also hear whooshing or sloshing noises from the appliance when it stops.
  • If the appliance is still not hot after an hour of the program, we recommend requesting a visit by a service engineer. (Report error code: JN).

 

2017-08-16_1122.png

To help you determine the exact nature of the problem, we recommend a visit by one of our authorized engineers to check the appliance and fix the problem.

When contacting us, please have the following information to hand. You will find this information on the manufacturer’s data plate:

  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

Data plate with model number, product number/PNC, ELC and serial number:

modelnoexplanation1.gif
  1. Model number
  2. Product number (PNC)
  3. ELC number
  4. Serial number

[3–9999] Where will I find the data plate on my product? 

NOTE: Depending on the problem, you may be charged for a service visit by an engineer, even during the warranty period.

Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.

  • Report error code: J1 (Or according to the instructions listed above).

Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.

You can request a visit by one of our engineers by clicking on the link below.